- #Classic mac vga adapter mac os#
- #Classic mac vga adapter drivers#
- #Classic mac vga adapter driver#
- #Classic mac vga adapter upgrade#
Avoid the red suction cup and you'll probably be just fine. Slowly slide the tip of the screwdriver underneath the red suction cup on the CRT until you hear a "pop," which indicates that the CRT is discharged.Īgain, you, the individual, take full responsibility for any damage done to yourself or your possessions, but just as a small side note, I have worked on many compacts and have never discharged a CRT and have suffered no ill effects. Clip the alligator clip to the Mac's chassis, making sure the Mac is plugged in. To make your own, take an alligator clip with a 12" (30cm) lead and firmly attach it with some sort of conductive material to the shaft of an insulated screwdriver. To discharge the CRT, use either Apple's CRT discharge tool or make your own. Neither Binhost Technologies, the pickle, Low End Mac, nor any other entity or individual other than the individual working on the CRT takes responsibility for any harm you may cause yourself by working with a potentially dangerous cathode ray tube. If you have a Plus or earlier with analogue board problems, and you know what needs to be replaced, check the parts list for a source.Ģ.1.5 - What is the proper CRT discharge procedure for Compact Macs?įirst, MAKE ABSOLUTELY SURE YOU ARE NOT GROUNDED.
#Classic mac vga adapter upgrade#
Hardy Menagh has compiled an up-to-date list of replacement analogue board parts for the Plus and earlier, based on Larry Pina's parts list in Mac Repair and Upgrade Secrets, and I have transcribed it into HTML format for easy consumption. Hamada's site for repairing the SE/30 has useful information for the SE and SE/30 analogue board repairs. While it doesn't have full instructions for all repairs, S. For a good soldering iron to use, see Question 2.8.8 in the Miscellaneous section.
(Backwards ROMs can cause this too.) If that doesn't work, try re-soldering the analog board connections at C1, J1, and L2. Make sure you also check to see if the ROMs are inserted the correct way. If you get a checkerboard pattern or a thin vertical or horizontal line but everything else seems OK, try removing the ROM and RAM chips, cleaning the contacts on them with a vinegar and salt solution (or a lemon juice and salt solution), and reseating the chips. There are several known problems with the video in the 128/512/Plus and in the SE or SE/30. The ATI extension is written in PPC-native code and does nothing on pure 68K Macs.Ģ.1.4 - How can I fix my Compact Mac's video problem?
#Classic mac vga adapter mac os#
Though Apple doesn't support it, Leon Sargent discovered that the ATI Graphics Accelerator extension will allow the 8*24GC to work fully under Mac OS 7.6 and later if the Mac has been upgraded with a PowerPC accelerator.
#Classic mac vga adapter drivers#
Gamba has some links to Radius, SuperMac, and E-Machines drivers at his site too.Ģ.1.3 - Can the Apple 8*24GC acceleration be enabled under Mac OS 7.6 and later?
#Classic mac vga adapter driver#
The Mac Driver Museum has drivers for a lot of Mac video cards and other hardware. The Apple KArchive has lots of Apple-specific information see Gamba's page or question 2.1.11 for more information.Ģ.1.2 - Where can I get drivers for my video card? Griffin Technology has a large database of monitors and video cards as well, and MonitorWorld has one too. There aren't many resources that explicitly state video card and monitor compatibility, but Gamba's video card-monitor matrix (mostly Apple-branded information) is a good place to start. Graphics Hardware Questions - the pickle's Low-End Mac FAQ Graphics Hardware 2.1.1 - What video cards work with what monitors?
0 kommentar(er)
